Novarossi Engine Parts

Novarossi Engine Parts

  • View

Active filters

Silicone Fuel line Transparent 1M

€2.40

This is a 2.5x6mm x 1m length transparent Ultimate Racing Silicone Fuel Line.

This ultra thick fuel line is an excellent choice for virtually all nitro racing applications. Made from special heat resistant silicone, this line is soft enough to bend around tight areas, while remaining firm enough to resist kinking.

With an outer diameter of 6mm, this line fits perfectly into the fuel tanks. This fuel line has been tested and trusted by many National and European champions.

Silicone Fuel line Transparent black 25 M

€41.24

This is a 2.5x6mm x 25m length transparent Ultimate Racing Silicone Fuel Line.

This ultra thick fuel line is an excellent choice for virtually all nitro racing applications. Made from special heat resistant silicone, this line is soft enough to bend around tight areas, while remaining firm enough to resist kinking.

With an outer diameter of 6mm, this line fits perfectly into the fuel tanks. This fuel line has been tested and trusted by many National and European champions.

Ultimate Racing silicone fuel line connector Golden

€2.48

This tube connector allows taking the fuel line out without removing from the tank or the pipe. It has been designed without any nipple avoiding fuel line potential damage. The inner size of the tube connector and the UR silicone fuel line is exactly the same, maintaining exactly the same fuel flow when the fuel goes through the fuel line connector.

Ultimate Racing silicone fuel line connector Purple

€2.48

This tube connector allows taking the fuel line out without removing from the tank or the pipe. It has been designed without any nipple avoiding fuel line potential damage. The inner size of the tube connector and the UR silicone fuel line is exactly the same, maintaining exactly the same fuel flow when the fuel goes through the fuel line connector.

Silicone manifold Gasket for 1/10 engines x2 pcs

€3.22

This is a pack of two replacement fir the 1/10 exhaust manifold gasket system. This is used to seal the back of .12 .15 .18 size rear exhaust engines where the tuned pipe manifold attaches to the rear of the engine. These eventually go bad and lose their seal over time due the intense heat of the engine, so it is good idea to replace these when they get worn out or you find they are leaking.